Article Sidebar
Main Article Content
Abstract
Stoving paint is used in refrigerators, fans, scooters etc. This paint doesn’t break because of high temperature. The stoving paint is prepared by the ball mill. After manufacturing, this paint is tested for flexibility and adhesion, hardness, resistance of acid and alkali, consistency and its volatile matter.
Keywords
Article Details
Copyright (c) 2007 Environment Conservation Journal
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
References
- Beck, F. and Kruger, U.A., 1996. Eis of cathodically deposited wet paint films prior to the stoving process. Electrochemica, 41(7/8):1083-1092. DOI: https://doi.org/10.1016/0013-4686(95)00441-6
- Benzer, Hakan, 2005. Modelling and simulation of a fully air swest ball mill in a Raw Material grinding Circuit. Power Technology, 150:145-154. DOI: https://doi.org/10.1016/j.powtec.2004.11.009
- Chibman, C. and Moys, 2006. Radial mixing of particles in dry batch ball mill. Power Technology, 163:139-144. DOI: https://doi.org/10.1016/j.powtec.2006.02.001
- Lameck, N.S., Kangr, K.K.and Moys, M.H., 2006. Effects of grinding media shapes on load behavior and mill power in a dry ball mill. Minerals Engineering, 19:357-1361. DOI: https://doi.org/10.1016/j.mineng.2006.01.005
- Marshall, G.L., Cuddy, M.E.A., Smith, K. and Harris, R.K., 1988. 13C CP-MAG Solid state n.m.r. spectra of stoving alkyd paints., Polymer, 29:501-1506. DOI: https://doi.org/10.1016/0032-3861(88)90316-3
References
Beck, F. and Kruger, U.A., 1996. Eis of cathodically deposited wet paint films prior to the stoving process. Electrochemica, 41(7/8):1083-1092. DOI: https://doi.org/10.1016/0013-4686(95)00441-6
Benzer, Hakan, 2005. Modelling and simulation of a fully air swest ball mill in a Raw Material grinding Circuit. Power Technology, 150:145-154. DOI: https://doi.org/10.1016/j.powtec.2004.11.009
Chibman, C. and Moys, 2006. Radial mixing of particles in dry batch ball mill. Power Technology, 163:139-144. DOI: https://doi.org/10.1016/j.powtec.2006.02.001
Lameck, N.S., Kangr, K.K.and Moys, M.H., 2006. Effects of grinding media shapes on load behavior and mill power in a dry ball mill. Minerals Engineering, 19:357-1361. DOI: https://doi.org/10.1016/j.mineng.2006.01.005
Marshall, G.L., Cuddy, M.E.A., Smith, K. and Harris, R.K., 1988. 13C CP-MAG Solid state n.m.r. spectra of stoving alkyd paints., Polymer, 29:501-1506. DOI: https://doi.org/10.1016/0032-3861(88)90316-3